From AIRWiki
Revision as of 12:02, 3 February 2010 by SimoneTognetti (Talk | contribs)

Jump to: navigation, search

(Jet WMH Tool Group) BD-8 Metal Lathe Diameter 20/450 mm Airlab Lambrate. Tornio.jpg

How to use

This is a short manual that describes how to use this tool. The manual came out from the course held in 2009. Note that only the people that have followed that course are allowed to use such machine!

Power on/off

If you are allowed to use the lathe use you personal key to switch on the general supply.

Control panel.jpg

Switch on the square button I/0 on the bottom part of the control panel. Red Rounded botton sorrounded by a yellow circle line is used for a rapid stop. Press to blok, rotate to unblok the lathe. 6 Oval buttons under the display are used for:

  • I(green): start the movement
  • O(red): stop the movement
  • Up arrow / Down arrow: Invert the rotation movement
  • + / - : Adjust the rotation speed. The speed depends on the material to work and to the type of lavoration: 300g/m for a rough lavoration, 600 g/m for a fine lavoration. 300g/m is good for Iron, Alluminium. For plastic, very slow rotation with high longitudinal velocity.

Refrigerant liquid is used only for strong material like stell. Do not use on alluminium

There exists a control to disconnect the part which keep the piece from the motor but it unuseful.