Microcontrollers and accessories
Here you can find a good introduction to the design of circuits based on PIC microcontrollers.
PIC by Microchip
In AIRLab/Lambrate you can find three Microchip ICD2 "debuggers" (Microchip product number DV164007).
All these devices should stay in the Lab! If removed, the person taking them have to write that he/she is taking it away on the table at the end of this section.
These are devices which let you write, read and run the code running on a PIC. To do that, the PIC can be accessed in two ways:
- if you were thoughtful enough, you designed your PCB including a port to connect to the pins of the PIC used for programming: in this case, the PIC can be left on the PCB and it is sufficient to hook up the ICD2 to the board with a suitable cable;
- if you were not so thoughtful (or if the PCB comes from someone else who wasn't), each time you need to communicate with the PIC you have to extract it from its socket and put it into an auxiliary board (Microchip product number AC162049) connected to the ICD2, then to put it back into the socket when you are finished.
Of course you have to POWER DOWN THE CIRCUIT when taking out the PIC or putting it back!
Four Olimex USB JTAG programmers are now available in AirLAB:
- one is in the workshop next to the ARM microcontrollers. (taken by [[User:StefanoCadario] on 27 july 2010)
- one is taken by User:MatteoRossi
- one is taken by Massimo Gandola and Diego Pizzagalli (tutored by User:MatteoMatteucci)
- one is in User:MatteoMatteucci office
If you want to remove these devices from the lab, please book in advance by adding an entry to the table. Please keep the table lines ordered by time (nearest bookings first); add new entries like this:
|Monday 13 March||11:00-18:00||Donald Duck|
|Friday 15 April||9:30-13:00||Mickey Mouse|
Use abbreviations, if you like. Please remove old entries.
- - - - - - -
ST REva Evaluation Board STM32 -> Martino Migliavacca (9/4/8) Olimex USB JTAG programmer -> Matteo Rossi (November 2009)