Difference between revisions of "VCSBC4018 vision board"

From AIRWiki
Jump to: navigation, search
Line 1: Line 1:
 
This tutorial explains how to use the camera board VCSBC4018.
 
This tutorial explains how to use the camera board VCSBC4018.
  
This camera board mount with a TMS320C64xx working at 40MHZ. The camera sensor can take images with a resolution of 640 x 480 pixels.
+
This camera board mounts a TMS320C64xx TI processor working at 40MHZ. The camera sensor can take images with a resolution of 640 x 480 pixels.
 
The board is equiped with a 100 Mbit Ethernet that allow to comunicate with a PC, 32 MB RAM and 4 MB flash EPROM. Power supply: 12~14V.
 
The board is equiped with a 100 Mbit Ethernet that allow to comunicate with a PC, 32 MB RAM and 4 MB flash EPROM. Power supply: 12~14V.
  

Revision as of 18:31, 17 July 2010

This tutorial explains how to use the camera board VCSBC4018.

This camera board mounts a TMS320C64xx TI processor working at 40MHZ. The camera sensor can take images with a resolution of 640 x 480 pixels. The board is equiped with a 100 Mbit Ethernet that allow to comunicate with a PC, 32 MB RAM and 4 MB flash EPROM. Power supply: 12~14V.

Part 1: HW connection

First of all it's needed to connect the LAN jumper (J4) and power jumper (J3). Jump.jpg

The photo above represent a generic board, in fact the VCSBC4018 doesn't have the J6 jumper.

The photo below shows the realy board with the two jumpers connected.

Collegamenti on board.jpg

The power (12~24V) must be connected to the red cable of J3 and the ground to the balck cable of the same connector. At the end, the RJ-45 connector must be plug into PC LAN port.