Difference between revisions of "VCSBC4018 vision board"
| Line 6: | Line 6: | ||
== '''Part 1: HW connection''' == | == '''Part 1: HW connection''' == | ||
| − | First of all | + | First of all you need to connect the LAN jumper (J4) and power jumper (J3). |
[[Image:jump.jpg]] | [[Image:jump.jpg]] | ||
| − | The photo above | + | The photo above represents a generic board, in fact the VCSBC4018 doesn't have the J6 jumper. |
| − | + | On the other hand, the photo below shows the real board with the two jumpers connected. | |
[[Image:Collegamenti on board.jpg]] | [[Image:Collegamenti on board.jpg]] | ||
| − | The power (12~24V) must be connected to the red cable of J3 and the | + | The power (12~24V) must be connected to the red cable of J3 and the GND to the balck cable of the same connector. |
| − | At the end, the RJ-45 connector must be | + | At the end, the RJ-45 connector must be plugged into PC LAN port. |
Revision as of 18:40, 17 July 2010
This tutorial explains how to use the camera board VCSBC4018.
This camera board mounts a TMS320C64xx TI processor working at 40MHZ. The camera sensor can take images with a resolution of 640 x 480 pixels. The board is equiped with a 100 Mbit Ethernet that allows to comunicate with a PC, 32 MB RAM and 4 MB flash EPROM. Power supply: 12~14V.
Part 1: HW connection
First of all you need to connect the LAN jumper (J4) and power jumper (J3).
The photo above represents a generic board, in fact the VCSBC4018 doesn't have the J6 jumper.
On the other hand, the photo below shows the real board with the two jumpers connected.
The power (12~24V) must be connected to the red cable of J3 and the GND to the balck cable of the same connector. At the end, the RJ-45 connector must be plugged into PC LAN port.
